hw:zynq:linux:start
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | |||
|
hw:zynq:linux:start [2021/04/21 14:44] jakub.moron |
hw:zynq:linux:start [2021/04/21 14:56] (current) jakub.moron |
||
|---|---|---|---|
| Line 2: | Line 2: | ||
| * [[:hw:zynq:linux:petalinux:start | PetaLinux 2018.3 install]] | * [[:hw:zynq:linux:petalinux:start | PetaLinux 2018.3 install]] | ||
| * [[:hw:zynq:linux:petalinux_2020.2:start | PetaLinux 2020.2 install]] | * [[:hw:zynq:linux:petalinux_2020.2:start | PetaLinux 2020.2 install]] | ||
| - | * [[:hw:zynq:linux:petalinux:boot_kernel | Boot and Kernel configure & build with PetaLinux without BSP (board support package) ]] | + | * [[:hw:zynq:linux:petalinux:boot_kernel | Boot and Kernel configure & build with PetaLinux 2018.3 without BSP (board support package) ]] |
| + | * [[:hw:zynq:linux:petalinux:boot_kernel_2020.2 | Boot and Kernel configure & build with PetaLinux 2020.2 without BSP (board support package) ]] | ||
| * [[:hw:zynq:linux:petalinux:boot_kernel_trenz | Boot and Kernel configure & build with PetaLinux for Trenz TEBF0808 ]] | * [[:hw:zynq:linux:petalinux:boot_kernel_trenz | Boot and Kernel configure & build with PetaLinux for Trenz TEBF0808 ]] | ||
| * [[:hw:zynq:linux:petalinux:rootfs | Root filesystem ]] | * [[:hw:zynq:linux:petalinux:rootfs | Root filesystem ]] | ||
| * [[:hw:zynq:linux:petalinux:sdcard | Setup SD card ]] | * [[:hw:zynq:linux:petalinux:sdcard | Setup SD card ]] | ||
/services/www/http/wiki/data/pages/hw/zynq/linux/start.txt · Last modified: 2021/04/21 14:56 by jakub.moron
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
