hw:zynq:linux:start
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
hw:zynq:linux:start [2019/03/20 11:21] jakub.moron |
hw:zynq:linux:start [2021/04/21 14:56] (current) jakub.moron |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| ====== Debian Stretch on Zynq ====== | ====== Debian Stretch on Zynq ====== | ||
| - | * [[:hw:zynq:linux:petalinux:start | PetaLinux install]] | + | * [[:hw:zynq:linux:petalinux:start | PetaLinux 2018.3 install]] |
| - | * Boot and Kernel setup & build with PetaLinux: | + | * [[:hw:zynq:linux:petalinux_2020.2:start | PetaLinux 2020.2 install]] |
| - | * [[:hw:zynq:linux:petalinux:boot_kernel_bsp | With BSP (board support package) ]] | + | * [[:hw:zynq:linux:petalinux:boot_kernel | Boot and Kernel configure & build with PetaLinux 2018.3 without BSP (board support package) ]] |
| - | * [[:hw:zynq:linux:petalinux:boot_kernel | Without BSP ]] | + | * [[:hw:zynq:linux:petalinux:boot_kernel_2020.2 | Boot and Kernel configure & build with PetaLinux 2020.2 without BSP (board support package) ]] |
| + | * [[:hw:zynq:linux:petalinux:boot_kernel_trenz | Boot and Kernel configure & build with PetaLinux for Trenz TEBF0808 ]] | ||
| + | * [[:hw:zynq:linux:petalinux:rootfs | Root filesystem ]] | ||
| + | * [[:hw:zynq:linux:petalinux:sdcard | Setup SD card ]] | ||
/services/www/http/wiki/data/attic/hw/zynq/linux/start.1553077312.txt.gz · Last modified: 2019/03/20 11:21 by jakub.moron
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
