hw:zynq:gpio_interrupt:start
This is an old revision of the document!
Table of Contents
GPIO with interrupts
Vivado design
Initial Vivado design – only Zynq + single AXI GPIO
- Open AXI GPIO properties (double click on block), go to
IP Configurationtab and enableEnable Interrupton bottom - Open Zynq Processing System, go to
Interruptstab, enable and unfoldFabric Interrupts;
unfoldPL-PS Interrupt Portand enableIRQ_F2P[15:0]
/services/www/http/wiki/data/attic/hw/zynq/gpio_interrupt/start.1553873631.txt.gz · Last modified: 2019/03/29 16:33 by jakub.moron
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
