This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
hw:zynq:linux:start [2019/06/05 11:34] jakub.moron |
hw:zynq:linux:start [2021/04/21 14:56] jakub.moron |
||
---|---|---|---|
Line 1: | Line 1: | ||
====== Debian Stretch on Zynq ====== | ====== Debian Stretch on Zynq ====== | ||
- | * [[:hw:zynq:linux:petalinux:start | PetaLinux install]] | + | * [[:hw:zynq:linux:petalinux:start | PetaLinux 2018.3 install]] |
- | * [[:hw:zynq:linux:petalinux:boot_kernel | Boot and Kernel configure & build with PetaLinux without BSP (board support package) ]] | + | * [[:hw:zynq:linux:petalinux_2020.2:start | PetaLinux 2020.2 install]] |
+ | * [[:hw:zynq:linux:petalinux:boot_kernel | Boot and Kernel configure & build with PetaLinux 2018.3 without BSP (board support package) ]] | ||
+ | * [[:hw:zynq:linux:petalinux:boot_kernel_2020.2 | Boot and Kernel configure & build with PetaLinux 2020.2 without BSP (board support package) ]] | ||
* [[:hw:zynq:linux:petalinux:boot_kernel_trenz | Boot and Kernel configure & build with PetaLinux for Trenz TEBF0808 ]] | * [[:hw:zynq:linux:petalinux:boot_kernel_trenz | Boot and Kernel configure & build with PetaLinux for Trenz TEBF0808 ]] | ||
* [[:hw:zynq:linux:petalinux:rootfs | Root filesystem ]] | * [[:hw:zynq:linux:petalinux:rootfs | Root filesystem ]] | ||
* [[:hw:zynq:linux:petalinux:sdcard | Setup SD card ]] | * [[:hw:zynq:linux:petalinux:sdcard | Setup SD card ]] | ||